User's Manual
Table Of Contents
- Permalog®
- Patroller
- Scope
- Introduction
- Safety warning
- Battery installation
- Checking Battery voltage
- Connections and interfaces to the Patroller
- Operating the Patroller
- On-Screen Menus
- Specifications
- Fuse information
- Conditions of Use of Permalog® System
- Permalog 1 Deployment Instructions
- Redeployment
- Permalog 2 Deployment Instructions
- Redeployment
- Warranty
- Patents
13
3. Deployment
Deployment
Serial 03997244
G.Ref SK 4321 6542
Area DMA 1625
Comment OUTSIDE 27 PARK AVE
Ent Accept
Esc Cancel
This is used when deploying Permalog
®
loggers on the network. It allows the
location details of each logger to be entered and stored in the internal
database. It also allows logger details to be edited or deleted from the
database.
Enter the logger serial number. Press Ent.
If the same serial number is re-entered, then a Deployment Error Screen is
displayed. You can either delete the entry or confirm it.
Enter the Grid reference of this logger. The first two characters must be
letters*. These are followed by numbers for the rest of the grid reference.
Press Ent.
Then enter the area details, up to 8 numbers or characters*.
Two seconds after entering a number, the cursor jumps along one digit.
Alternatively you can use the left/right arrow keys.
* To enter letters instead of numbers, press the relevant keypad button
twice or more as required. The numbers and letters step through in sequence
and return to the start point again. For the area details the first character to
appear is always a number. In the Comments section, this is reversed so that
letters come up first.
The system works as shown in this example:-
Press button 2. The number 2 appears.
Press button 2 again. The letter A appears.
Press button 2 again. The letter B appears.
Press button 2 again. The letter C appears.
Press button 2 again. The number 2 reappears.
To enter a space, press 0 (zero) twice.