User's Manual
Table Of Contents
- Permalog®
- Patroller
- Scope
- Introduction
- Safety warning
- Battery installation
- Checking Battery voltage
- Connections and interfaces to the Patroller
- Operating the Patroller
- On-Screen Menus
- Specifications
- Fuse information
- Conditions of Use of Permalog® System
- Permalog 1 Deployment Instructions
- Redeployment
- Permalog 2 Deployment Instructions
- Redeployment
- Warranty
- Patents
11
2. Patrol menu
Patrol Menu
1. Max Range
2. Mid Range
3. Min Range
4. Logger Details
5. Closest Loggers
6. Patrol Setup
7. Clear Display
8. Restore Display
9. Print Results
0. Reset Logger Entry
Ent Leak Patrol
Esc Main Menu
1. High/Max range
Sets high sensitivity on the radio receiver to achieve maximum range,
typically greater than 50 m.
2. Medium range
Sets medium sensitivity on the radio receiver for a range of typically 15 m.
In an area where many loggers are in range, this can be used to limit the
number of received signals.
3. Low/Minimum range
Sets low sensitivity on the radio receiver for a typical range of 5 m. This
may be used to ‘home-in’ on one particular logger.
4. Logger Details
Press 4, then enter a serial number and press Ent to view the stored
results for a given logger. The default serial number is the currently
highlighted logger. The display shows the level, spread and date received
of the last 6 results, along with the deployment details. Press Esc to return
to the Patrol menu.
5. Closest Loggers
To find the closest loggers to a particular logger, first select the Leak
Patrol screen and check the appropriate logger is selected. Alternatively,
select the Patrol menu and press 4 to enter logger details. Type in the
serial number of the logger you are interested in and press Ent to search
for it. The selected logger details are displayed. Press Esc to return to
the Patrol Menu. Press 5