User Guide

110 Section 3A: Sprint Power Vision
Setting Up a Data Connection With Your Computer
To use your phone as a modem, you first need to load the Sprint Connection Manager
software on your computer, and then use the sync cable to connect your device to your
computer.
To set up your phone-to-computer data connection:
1. Install the Sprint Connection Manager software and drivers located on the Palm
Software Installation CD.
2. After you install the software, connect your device to your computer using the sync
cable. (When your computer detects the connection, the icon appears in the taskbar
in the lower-right corner of your computer screen.)
3. Make sure your device’s phone is turned on (see “Turning Your Device’s Phone On and
Off” on page 61) and that one of the Vision icons ( or ) appears at the top of the
screen.
4. On your computer, open the Sprint Connection Manager software, select your device
name, and then click Connect.
5. Once the connection is established, launch an Internet session, check your email, or do
anything else you would do using a traditional Internet connection.
Tip
If your computer is enabled with Bluetooth
®
wireless technology, you can
also use your device as a wireless modem. See “Using Your Device as a
Wireless Modem” on page 173.
Note
If neither icon appears, you cannot use your device as a modem with Sprint
Connection Manager.