User's Manual

Regulatory and Safety Information 49
Regulatory and Safety Information
FCC Statements
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This phone meets the FCC Radiofrequency Emission Guidelines and is certified with
the FCC as:
FCC ID: O8F-CASY
The FCC ID on your Palm phone is located on a label inside the battery compartment.
The battery must be removed as shown below to view the label.
Antenna Care/Unauthorized Modifications
Use only the supplied integral antenna. Unauthorized antenna modifications or
attachments could damage the unit and may violate FCC regulations.
EU Regulatory Conformance
We, Palm, Inc., hereby declare that this device is in conformance to all essential
requirements of the R&TTE Directive 1999/5/EC.
This equipment is marked with the 0984 symbol and can be used throughout
the European community.
This indicates compliance with the R&TTE Directive 1999/5/EC and meets the
relevant parts of following technical specifications:
• ETSI EN 301 511
• ETSI EN 301 908-1
• ETSI EN 301 908-2
• ETSI EN 300 328
• ETSI EN 301 489-1/-7/-17/-24
• EN 60950-1
•EN 50360
•EN 50371
Marking by the symbol indicates this equipment uses non-harmonized frequency
bands.
France - 2.4GHz for Metropolitan France:
In all Metropolitan departments, wireless LAN frequencies can be used under the
following conditions, either for public or private use:
• Indoor use: maximum power (EIRP*) of 100 mW for the entire 2400-2483.5 MHz
frequency band