User's Manual

10 Chapter 1 : Basics
8 Position the back cover over the phone and gently press the top two
clasps (a), located at the top corners. Then press the two clasps (b)
halfway down either side of the phone.
9 Slide out the keyboard (see Slide out the keyboard), and then press the
two clasps (c) at the bottom corners.
10 Press and hold the power button on the upper-right corner of your
phone until you see a logo on the screen (approximately five seconds).
Please be patient while your phone starts up.
11 Follow the onscreen instructions to complete setup.
12 To create a Palm profile, enter a working email address and select and
answer a security question (see What is a Palm profile?).
NOTE If you have a Palm profile from an old webOS phone that you no longer
use, you can enter that profile email address and username to download that
profile information to your new phone. But if you are still using the other phone,
you must create a new Palm profile for your Pre Plus phone—you can’t use the
same profile on two phones.
13 Your phone is ready to use. To learn how to make your first call, see
Make calls.
Verify your profile
After you finish setup, look for an email on your computer at the address you
used for your Palm profile. If you don’t see the confirmation email in your
Inbox, check your spam mail folder in your desktop email program. Click the
link in the email to do the following:
• Verify your Palm profile.
• Follow a link to learn about getting data like contacts and appointments
onto your phone from your desktop organizer software.
TIP If your phone does not turn on after you insert the battery and press and hold
power, you need to connect your phone to the AC charger to charge it (see
Charge the battery).