Product Info

Palm.Net™ Service Agreement and Other Product Information Page 285
12.8 Arbitration. All disputes, claims, and controversies between the parties aris-
ing out of or related to this Agreement or the breach thereof (except for non-payment or
late payment; and breach of any obligation of confidentiality or infringement of any in-
tellectual property right for which an injunction may be sought) shall be settled by ar-
bitration. The arbitration shall be conducted by one arbitrator under the then current
Commercial Arbitration Rules of the American Arbitration Association. The power of
the arbitrator shall be limited to that possessed by a Superior Court Judge in California.
The arbitrator is prohibited from awarding damages or remedies in excess of those al-
lowed by the provisions of this Agreement. The decision and award of the arbitrator
shall be final and binding and judgment on the award so rendered may be entered in
any court having jurisdiction thereof. The arbitration shall be held in Santa Clara Coun-
ty, California, or a mutually convenient location, and the award shall be deemed to be
made in California.
12.9 Survival
. Sections 4 (“Charges and Billing Practices”), 5.3 (“Additional Charg-
es”), 8 (“Disclaimer of Service Warranties”), 9 (“Limitation Of Liability For The Ser-
vice”), 11.4 (“Indemnification”), and 12 (“General”) shall survive the expiration or
termination of this Agreement.
Product regulatory information
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.