User's Manual

Conducting network HotSync operations
299
5. If your user name does not appear, click New, enter your user name and
click OK.
6. Click OK.
7. Perform one of the following:
– Put your handheld in the cradle/cable, and perform a HotSync operation.
The HotSync operation records network information about your computer
on your handheld. With this information, your handheld can locate your
computer when you perform a HotSync operation over the network. You are
ready to perform a network HotSync.
– Perform a network HotSync operation. You will need to go through a setup
procedure on your handheld.
Performing a wireless network HotSync operation
After you prepare your computer and select your Conduit Setup options, you are
ready to perform a wireless network HotSync operation.
IMPORTANT You must first install the Palm Desktop software that came with your
Tungsten C handheld before your attempt a network HotSync operation. Your
computer must have the software installed to communicate with your handheld.
If you already performed a cradle/cable HotSync operation, you are ready for
network HotSync operation with no further preparation needed.
If you did not perform a cradle/cable HotSync operation, you must set up from
your handheld.
To perform a wireless network HotSync operation:
1. Press Home .
2. Tap the HotSync icon .
DRAFT Palm, Inc. Confidential