Plank Installation Guide PALISADE READ tis entire installation guide before beginning your installation. ACP is not responsible and will not be held label for project failures if installation guidelines are not followed. ACP commands that you install these planks over an existing substrate to ensure proper structural integrity. Palisade planks ara not intended to be attached (© raw congrats, poured concrete walls or concrete block basement walls.
Qut planks for tourists and light switches. Measure and mark the borders whats the opening will be with a marker. Drill & hole using a drill in a corner of tha cut-out section {image FJ. Use & fig saw io out the remaining opening, following your tracing (mags G). Do not atishoo accessories lke coat hooks, light fittings, minors, ele. directly to the planks. Drill halos through the ties and use suitable anchors to attach the accessories securely Into the framing behind. Seal par sealant Instructions.
Net, determine the length of the plank section. Measures from the inside (ip of the previously installed plank fo the inside adj of the per-installed rim. See image at right for details. In this case, the length to out the final plank in the row is (image CJ. After cutting plank to length, apply adhesive to the substrate, as shown (mags R). Insert the cut plank eds into the L-trireme while holding the interlocking joint-edge away from ite mating plank.
