Instructions

Place the Vehicle detector at the center of rote
on a clean surface so it will be placed in center
path, so vehicles will pass when it is the vehicle
center as much as possible.
Vehicle Detector
Installation Instructions
Highlights
• Power provided by a buttery which will last for
approximately 5 years (1000 entrances per
day).
• Holds approximately 1000 kg weight
•
• WARNING: Not To Be Used for Personnel
Protection
----------------------------------------------------------------------------------------------------------------------
PAL Electronics Systems, HaTa'asiya 25 st, Ra'anana, Israel 4365413, POB 2516
Tel:[phone], Website:
www.pal-es.com, Email: [e-mail].(6)
Path center
Max 7m’
1
2
3
Preparations
: Add the new detector to Pal SG
304
–
**
WR
unit (receiver) with RF technology such: GI-WR, 4GI-L-
WR, GB-WR Pal access control units. Enter the
detector/s identification numbers.
To activate the detector, use the magnet provided
along with the detector. Put the magnet on the set-up
point and wait for 3 beep sounds slowly and a final long
sound. After the long sound remove the magnet at
least 1 meter from the detector.
Before installation
• Remove 4 screws from bottom cover
• Open the bottom cover
• Connect the jumper to it’s place.
• Close back the cover but very important to
place the seal back to its place.