Pairlink Rabbit Bluetooth 5 BLE module : User's Guide : Page 13

Rabbit-B User Guide

www.pairlink.com.cn

- 13 -

Cetéquipementestconforme aux limitesd'exposition aux rayonnements IC établies pour

unenvironnement non contrôlé. Cetéquipementdoitêtreinstalléetutilisé avec un minimum

de 20cm de distance entre la source de rayonnement et votre corps.

OEM Integration Instructions：

This device is intended only for OEM integrators under the following conditions：

The module can be used to installation in other host. The transmitter module may not be

co-located with any other transmit or antenna. The module shall be only used with the

integral antenna(s) that has been originally tested and certified with this module. As long as

3 conditions above are met, further transmitter test will not be required. However, the OEM

integrator is still responsible for testing their end-product for any additional compliance

requirement with this module installed (for example, digital device emission, PC peripheral

requirements, etc.). OEM integrator is responsible for ensuring the end-user has no manual

instruction to remove or install module.

IMPORTANT NOTE：

In the event that these conditions cannot be met (for example certain laptop configuration

or co-location with another transmitter), then the FCC authorization for this module in

combination with the host equipment is no longer considered valid and the FCC ID of the

module cannot be used on the final product. In these and circumstance, the OEM integrator

will be responsible for re-evaluating. The end product (including the transmitter) and

obtaining a separate FCC authorization. The final end product must be labeled in a visible

area with the following: “Contains Transmitter Module FCC ID: 2AQV6RABBIT”.

Antenna Specification:

Antenna Type

Manufacturer

Frequency Range

(MHz)

Maximum Peak

Antenna Gain(dBi)