User's Manual

17
6.4 TAIL SECTION INSTALLATION
6.4.1 Locate the tail section that you earlier separated from the engine group. Begin routing it towards
the rear of the vehicle. Be sure to avoid all sharp edges, moving or hot parts, or anything else that
may damage the harness.
6.4.2 If you ARE using the 4L60E transmission, route the 13-position connector to the transmission and
plug it in. Tape up the reverse lockout and skip shift solenoid connectors and store them in the
harness.
6.4.3 If you ARE using the T56 manual transmission, route the reverse lockout and skip shift solenoid
connectors to the transmission and attach them. Tape up the 13-position connector labeled TRANS
and store it in the harness.
6.4.4 Take the connector for the Vehicle Speed Sensor (VSS) and connect to the Vehicle Speed Sensor.
6.4.5 Take the gray wire labeled FUEL PUMP and route it to the fuel pump. This is the power wire for
the fuel pump.
6.4.6 Tail Section Connections
WIRE COLOR: # OF WIRES: LABELED: CONNECT TO:
Purple/White, Lt.Grn/Black
Pink, Lt.Green
Pink, Gray
Blue, Pink (2), Lt.Green, Red, Brown,
Yellow/Red, Orange/Black, White,
Tan/Black, Lt.Blue/White, Red/Black,
Yellow/Black
Gray
2
2
2
13
VSS
Reverse Lockout Sol.
Skip Shift Sol.
Transmission
Fuel Pump
Vehicle Speed Sensor
Reverse Lockout Solenoid
Skip Shift Solenoid
Transmission (4L60E)
Fuel Pump Power Term
FIGURE 6.24 VSS (4L60E)
FIGURE 6.25 Transmission Connection (4L60E)
TABLE 6.3 Tail Section Connections