User's Manual

13
6.3 ENGINE GROUP INSTALLATIONS
The engine group is designed to be separated into left side (driver) and right side (passenger) sections. Each
side is tie-wrapped separately, BUT NOT LABELED. The left side of the engine has the connectors for
the cam position sensor, alternator, and engine coolant sensor, all of which ARE labeled. When you begin
routing, FIRST separate the engine group into left and right sections and place them accordingly.
6.3.1 Before you connect any wires, separate the tail section from the engine group and place it out of
the way.
6.3.2 Connect the two ring terminals labeled STARTER B+ with Red wires to the large battery terminal
on the starter solenoid.
6.3.3 Locate the three large ring terminals with Black and Blk/Wht wires and ground them to the engine.
6.3.4 Using Figure 6.7-6.25, and the specific connections indicated in Table 6.2, connect the wiring as
directed.
6.3.5
Engine Section Connections
WIRE COLOR: # OF WIRES: LABELED: CONNECT TO:
Lt. Blue
1
Blue
1
Tan/White, Purple/White, Black, Pink
Tan, Purple, Black, Pink
Orange/Black, Lt.Green, Gray
Brown/White, Red, Pink/Black
Blue/White, Yellow/Black, Lt.Green
Pink, Black
Pink, Lt.Green/Black
Pink, Pink/Black
Pink, Lt.Blue/Black
Pink, Black/White
Pink, Yellow/Black
Pink, Red/Black
Pink, Blue/White
Blue, Grn, Ppl, Brn, Pnk, Ylw
Yellow, Black/White, Pink, Purple, Tan
Black, Yellow
Purple, Red, Green, Lt.Blue, Brown,
Black, Pink
Red/White, Purple/White, Lt.Blu/Wht,
Grn/Wht, Brn/Wht, Blk, Pnk
Black (3), Black/White (3)
Red (2)
Red, Grey
Tn/Wht, Blk, Gry
1
1
4
4
3
3
3
2
2
2
2
2
2
2
2
6
5
2
7
7
6
2
2
3
Knock #2
Knock #1
Drvr Side Oxy
Pass Side Oxy
MAP
CMP
CKP
Inj #1
Inj #2
Inj #3
Inj #4
Inj #5
Inj #6
Inj #7
Inj #8
Throttle Body
MAF/IAT
ECT
Drvr Coils
Pass Coils
Ground
Starter B+
Alt.
Oil Pressure
Passenger Side Knock Sensor
Driver Side Knock Sensor
Driver Side Oxygen Sensor
Pass Side Oxygen Sensor
MAP Sensor
Cam Position Sensor
Crankshaft Position Sensor
Driver Side Front Injector
Passenger Side Front Injector
Driver Side 2
nd
Injector
Passenger Side 2
nd
Injector
Driver Side 3
rd
Injector
Passenger Side 3
rd
Injector
Driver Side Rear Injector
Passenger Side Rear Injector
Throttle Body
MAF/IAT Sensor
Engine Coolant Temp Sensor
Driver Side Coil Connector
Pass Side Coil Connector
Engine Ground
Starter Solenoid Batt. Term
Alternator
Oil Pressure Sensor
1. Knock sensors will thread into the extra mounting holes on each side of the engine block. See Figure
6.8 and Figure 6.23 for the correct location to install the knock sensors.
TABLE 6.2 60520-21 Engine Section Connections