Palapala a ka mea nona

22
AUTOMATIC WATER DISPENSER
Your refrigerator might be equipped with
an internal water dispenser mounted inside
the cabinet, along the left-hand cabinet
wall (varies by model).
Before using the water dispenser for the
first time or after changing the water filter,
you must prime your water supply system.
The water nozzle inside the cabinet allows
the water nozzle (A) to be recessed
against cabinet when not in use and to
be extended outward when in use. To
use the water dispenser, push the water
nozzle (A) so it is fully extended. Place a
cup against the paddle (B) and press to
dispense water.
A
B
Water Dispenser
On
Water Dispenser
O
Priming the water supply system
Using the dispenser after installation:
If the system is not flushed, the first glass
of water may have discolored water or
have an odd flavor.
1. Begin filling the system by pressing
a drinking glass against the water
dispenser paddle.
2. Keep the glass in this position
until the water comes out of the
dispenser. It may take about 1½
minutes.
3. Continue dispensing water for
about 4 minutes to flush the system
and plumbing connections of any
impurities (stopping to empty the
glass as necessary).
If the water dispenser function becomes
disabled, enable the water dispenser by
pressing and holding WATER DISP on the
appliance control display. When the water
dispenser is turned on, the LEDs above
WATER DISP are illuminated.

NOTE
Optional: Lock the water dispenser
back in place by pushing the water
nozzle back in when you have finished
dispensing water.

NOTE
If you prefer to keep the internal water
dispenser disabled, use the appliance
display to disable it. The LEDs will not
be illuminated above WATER DISP.
CAUTION
For proper dispenser operation, the
recommended water supply pressure
should fall between 30 psi and 100
psi. Excessive pressure may cause the
system to malfunction.