Palapala a ka mea nona

ManualsBrandspahi kahi ManualsOtherRazor Crazy Cart XL 36V Electric Drifting Go Kart

HOW TO OPERATE THE CRAZY CART XL

Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information

at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer

Service contact information is listed at the back of this manual.

Your Crazy Cart XL has been shipped with the Drift Bar in the unlocked position (without the Drift Bar Lock Knob

installed) allowing for full use of the Drift Bar functions. Use of the Drift Bar is recommended for experienced riders

allowing ultimate drift control. It is recommended that you follow the directions below for “Driving with Drift Bar

Locked” while you get comfortable with the unique riding and drifting capabilities of the Crazy Cart XL.

Note: Lock Knob removal and installation procedures should be made without a rider sitting in the

product and with the power turned off.

Driving with Drift Bar Unlocked

Removing the Drift Bar Lock Knob frees up the Drift Bar to give drivers dynamic control over the angle of the caster

wheels, which allows driving that is otherwise impossible. Drivers can control the angle of the caster wheels by

moving the Drift Bar back and forth.

In order to unlock your Drift Bar and allow drivers to dynamically control the degree of incline on the rear casters,

simply remove the Lock Knob.

Driving with Drift Bar Locked

Great for beginners and for racing friends. Locking the Drift Bar simpliﬁes the controls and allows drivers to keep

both hands on the steering wheel without having to worry about the Drift Bar popping up if you turn too hard.

In order to lock your Drift Bar, simply install the Lock Knob.

Installing the Lock Knob

Removing the Lock Knob

1 Pull the Drift Bar up so that the

hole on the Drift Bar lines up with

the threaded hole on the baseplate.

1 Remove the Lock Knob by turning

it counterclockwise. Keep the Lock

Knob for future use.

2 Insert Lock Knob through Drift

Bar and into the threaded hole on

the baseplate (Note: Holding the

Drift Bar up while threading in the

Lock Knob will make it easier to

thread the Lock Knob into place).

3 Turn the Lock Knob clockwise as

far as you can to secure it in place.

Do not overtighten.

Lock Knob