Palapala a ka mea nona

12
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
TROUBLESHOOTING GUIDE
Problem Possible Cause Solution
Product does not run. Undercharged battery.
Charger is not working.
Charge the battery. A new battery should have been charged for
at least 12 hours before using the product for the first time and up
to 12 hours after each subsequent use.
Check all connectors. Make sure the charger connector is tightly
plugged into the charging port and that the charger is plugged
into a functioning wall outlet.
Contact Razor Customer Service to get replacement charger.
Product was running but suddenly
stopped.
Loose wires or connectors. Check all wires and connectors to make sure they are tight.
Short run time. Undercharged battery.
Battery is old and will not accept
full charge.
Charge the battery. A new battery should have been charged for
at least 12 hours before using the product for the first time and up
to 12 hours after each subsequent use.
Refer to page 5. Replace only with a Razor replacement battery.
Product runs sluggishly. Riding conditions are too stressful.
Product is overloaded.
Use only on solid, flat, clean and dry surfaces, such as pavement
or level ground.
Make sure you do not overload the product by allowing more than
one rider at one time, exceeding the maximum weight limit, going
up too steep a hill or towing objects behind the product.
Sometimes the product doesn’t run,
but other times it does.
Loose wires or connectors.
Motor or electrical switch damage.
Check all wires connectors to make sure they are tight.
Contact your local Razor authorized service center for
diagnosis and repair. Contact Razor customer service or
visit www.razor.com.
Charger gets warm during use. Normal response to charger use. No action required. This is normal for some chargers and is no
cause for concern. If your charger does not get warm during use,
it does not mean that it is not working properly.
Product makes loud noises or
grinding sounds.
Chain is too dry. Apply a lubricant such as 3 in 1
™
or Tri-Flow
™
to the chain.
For more troubleshooting tips, a list of available replacement parts or to locate an authorized Service Center in your area,
visit our website at www.razor.com or call toll free [phone] to speak to a live Customer Service Representative.
*Product(s) should be turned OFF and fully charged prior to doing any Troubleshooting.
NOTE: All troubleshooting steps should be performed by an adult only.