OWNER’S MANUAL Read and understand this entire manual before allowing child to use this product! For assistance contact Razor. DO NOT RETURN TO STORE. NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice. Please have your product along with the 19 character product I.D. code with you before contacting Razor for warranty assistance and/or replacement parts. Product I.D.
CONTENTS Safety Warnings.............................................................................................1-2 Before You Begin ...............................................................................................3 Assembly and Set-Up ........................................................................................4 Charging the Battery .........................................................................................5 Pre-Ride Checklist ....................................
SAFETY WARNINGS Do not turn the power switch in the Crazy Cart XL to ON or depress/ activate the accelerator pedal unless you are seated and in a safe, outdoor environment suitable for riding. Always turn the power switch to OFF before exiting the Crazy Cart XL. PROPER RIDING ATTIRE Always wear proper protective equipment, such as an approved safety helmet (with chin strap securely buckled). A helmet may be legally required by local law or regulation in your area.
BEFORE YOU BEGIN Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the Crazy Cart XL was 99 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents. MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE PROCEDURES.
ASSEMBLY AND SET-UP Turn power switch “OFF” before beginning repair or maintenance: Attaching the Seat 1 Pull seat back until seat locks securely in place. Attaching the Flag 1 Insert flag. Inflating the Tire Tire is inflated when shipped, but it will invariably lose some pressure between the point of manufacturing and your purchase. Before initial use: Using a bicycle style tire pump equipped for a Schrader-type valve, inflate the front tire to the correct PSI indicated on the sidewall of the tire.
CHARGING THE BATTERY Your Crazy Cart XL may not have a fully charged battery; therefore you must charge the battery prior to use. • Initial charge time: 12 hours. • Recharge time: Up to 12 hours, even if the light turns green. • Always charge the battery immediately after riding. • Fully charge battery before storing for extended periods of time. • Unplug charger from the wall outlet when not in use. • Failure to recharge battery periodically may result in a battery that will not accept a charge.
HOW TO OPERATE THE CRAZY CART XL Before you ride this exciting product, take the time to learn about how it moves the way it moves. Start out slowly. With practice and care, you must familiarize yourself with these riding hints and tips so that your experiences with the Crazy Cart XL will allow you to maximize fun while keeping in control. Never turn the Power Switch to ON before sitting down in the driver’s seat of the Crazy Cart XL.
HOW TO OPERATE THE CRAZY CART XL Drift Bar for Adjustable Casters The wheels on the Crazy Cart XL are mounted on casters, like RipStik wheels. By altering the angle of the support for these wheels, the Crazy Cart XL can either “track” in the same direction as the drive tire is going or allow the rear end to “drift” in response to turning or acceleration forces.
HOW TO OPERATE THE CRAZY CART XL Your Crazy Cart XL has been shipped with the Drift Bar in the unlocked position (without the Drift Bar Lock Knob installed) allowing for full use of the Drift Bar functions. Use of the Drift Bar is recommended for experienced riders allowing ultimate drift control. It is recommended that you follow the directions below for “Driving with Drift Bar Locked” while you get comfortable with the unique riding and drifting capabilities of the Crazy Cart XL.
REPAIR AND MAINTENANCE Turn power switch “OFF” before beginning repair or maintenance: • Read the instructions • Secure the product under repair • Remove charger plug • Exercise caution around exposed parts • Turn the power switch off • Contact Razor customer service if unsure about any repair or maintenance Front Tire/Chain Replacement Required Tools: Phillips Screwdriver, 4 mm Allen Wrench, and Two (2) 16 mm Wrenches (not included) OFF 4 mm Allen Bolt 1 Using a Phillips screwdriver, 2 Using two (
REPAIR AND MAINTENANCE Front Tire/Chain Replacement - continued OFF 4 mm Allen Bolt 7 Re-attach the chain guard with 8 Use two (2) 16 mm wrenches to 9 Re-attach the motor cover with the screws removed in step 3. re-secure front tire in place. the hardware removed in step 1. Caster Wheel Replacement Required Tools: Two (2) 5 mm Allen Wrenches (not included) Note: Practice riding only in wide open areas clear from curbs, parking blocks and other obstacles.
REPAIR AND MAINTENANCE Caster Replacement Required Tools: 22 mm Wrench and Two (2) 5 mm Allen Wrenches (not included) 22 mm 1 Carefully turn product over. Using 2 Using a 22 mm wrench, loosen 3 Insert replacement caster into two (2) 5 mm Allen wrenches loosen the coupling bolt that attaches the wheel to the caster; remove wheel. and remove caster from frame. the frame and secure in place using a 22 mm wrench. Re-attach wheel to caster and secure in place with coupling bolt removed in step 1.
TROUBLESHOOTING GUIDE *Product(s) should be turned OFF and fully charged prior to doing any Troubleshooting. NOTE: All troubleshooting steps should be performed by an adult only. Problem Possible Cause Solution Product does not run. Undercharged battery. Charge the battery. A new battery should have been charged for at least 12 hours before using the product for the first time and up to 12 hours after each subsequent use. Charger is not working. Check all connectors.
CRAZY CART XL PARTS Keep your product running for years with genuine Razor parts. Visit our website or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 1. 2. 3. 4. 5. 6. 7. 8. Seat Motor Covers (Right/Left) Steering Wheel Headset (Upper/Lower) Stabilizing Posts (x2) Front Fork Chain Tensioner Motor 9. 10. 11. 12. 13. 14. 15. 16. Chain Chain Guard Front Wheel Control Module On/Off Switch Charge Port Casters (x2) Wheels (x2) 17. 18. 19. 20. 21.
NOTICE: INSURANCE YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
FCC COMPLIANCE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
