Operation Manual

If the charger is used in a Permanent / Hard Wired application and the vehicle
will not be used for some time, it is best to leave the charger connected to
mains power (turned 'On') so that it can maintain the battery fully charged.
Ensure any modification to the 110V/220-240V AC mains lead is carried out by
a qualified person and that connection to supply mains is in accordance with
National wiring rules.
14
Inline fuse
RED
BLACK
Ring terminal
OUT PUT
12V D C
INP UT
AC
7-STAGE AUTOMATIC CHARGING
P/No.: MBC 121 0
INPUT: 220-240V AC, 50/6 0Hz, 307W
OUTPUT: 12V DC, 10,000 mA
FUSE: T3.1 5A, 250V AC
FAN
CHA SSIS
GND
ON
OFF
Connection:
1. Cut off the supplied battery clips; ensure you leave sufficient cable to reach
the battery terminals. (DO NOT extend the battery charger DC cables, as the
added voltage drop will cause incorrect charging).
2. Fit a ring terminal to the BLACK Negative (-) wire.
3. Connect the inline fuse to the RED Positive (+) wire.
4. Connect a ring terminal to the other end of the inline fuse.
5. Connect the RED lead (with inline fuse and ring terminal) to the Positive (+)
battery post.
6. Connect the BLACK lead (with ring terminal) to the Negative (-) battery post.
7. Fit the correctly rated fuse.