Quick Installation Guide

ManualsBrandsPacketalk ManualsComputers & AccessoriesIEEE802.11ac Access point

PT420 Quick Installation Guide

Introduction

This document will guide users on how to setup the main functions of the PT420.

Contents

Introduction ............................................................................................................ 1

Contents .................................................................................................................. 1

Configuration Guide ................................................................................................ 2

I. Connecting PT420 and Login ........................................................................... 2

II. Setup LAN Interface ........................................................................................ 4

III. Setup Wireless Interface ................................................................................. 5

IV. Factory Default ............................................................................................... 6

Summary of content (7 pages)

PAGE 1
PT420 Quick Installation Guide Introduction This document will guide users on how to setup the main functions of the PT420. Contents Introduction ............................................................................................................ 1 Contents .................................................................................................................. 1 Configuration Guide ................................................................................................ 2 I.
PAGE 2
Configuration Guide I. Connecting PT420 and Login Please follow the instructions step by step to complete the setup successfully. TOPOLOGY SETUP STEPS 1. Power on PT420, CONNECT PT420 WAN port to PoE switch using a RJ45 cable. 2. LOGIN the Router with DHCP server, check DHCP release table and find the IP released to PT420. 3. 4. Assume PT420 WAN IP is 192.168.1.100. OPEN Chrome or Firefox web browser and go to URL link: http://192.168.1.100:8080 ENTER default Username, root. Leave Password as blank.
PAGE 3
PAGE 4
II. Setup LAN Interface This section shows how to configure PT420 LAN interface. SETUP STEPS 1. Login PT420, go to Network → LAN Settings and SET IPv4 address to the IP you need, default value is 192.168.188.253. 2. If you need to setup LAN DHCP server, the next area will allow user to configure the startup IP, IP number and lease time.
PAGE 5
III. Setup Wireless Interface This section shows how to configure PT420 wireless interface. SETUP STEPS 3. Login PT420, go to WiFi → 5G Wifi. In Basic setting, user can disable wireless interface, change SSID, modify channel Bandwidth and tune the Channel. User also can change Encryption and Key. 4. In Advance setting, user can change Country Code and Mode.
PAGE 6
IV. Factory Default This section shows how to recover the Factory Default Settings to the PT420. SETUP STEPS 1. Login PT420, go to Manage → Configure and CLICK Reset Default.
PAGE 7
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.