User Manual

Packet Power™ Smart Power Cable User’s Manual
Copyright 2012 © Packet Power, LLC.
1
Safety summary and specifications
This manual is intended for use by personnel responsible for installing or removing the
Smart Power Cables. Packet Power LLC assumes no liability for user’s failure to comply
with these safety guidelines. Please read this manual carefully before proceeding.
This symbol is used throughout this manual to indicate critical safety
information. Failure to observe the information following this symbol may
result in injury or death.
Smart Power Cables should only be connected to the type of power source
indicated on the label.
Do not overload a Smart Power Cables as this can result in a risk of fire or
electrical shock.
Cables shall be connected according to their amperage ratings to a proper branch
circuit protector.
Cables must be connected to a terminal that is compatible with the connector on the
cable and has the appropriate electrical rating.
Cables must be connected to a grounded (earthed) outlet.
Adhere to all local and national electrical codes and guidelines.
Prior to installation, check to make sure the Smart Power Cable has not been
damaged.
Store in a clean, dry location.
Intended for indoor use only. Do not install in a wet location.
No field-serviceable parts. Do not attempt to disassemble the product as potentially
severe electrical shock may result. Installation and maintenance must be performed by
qualified personnel.
Failure to use the product in the specified manner may lead to injury or death and
damage to equipment.
The “R” Model Smart Power Cables will support three-phase or single-phase
power. Please note carefully the type of power your cable is designed to
support as indicated on the cable’s label. Use only with the indicated type of
power.