User Manual

Packet Power™ Smart Power Cable User’s Manual
Copyright 2012 © Packet Power, LLC.
11
 Once energized the Gateway will indicate it’s firmware version, then device ID number (also
found on the top label of the Gateway) followed the IP address (may be blank if operating
DHCP mode); note that the IP address may take up to two minutes to display.
POWER UP DISPLAY SEQUENCE
Menu Access and Navigation
To access the menu for the Gateway, press and hold the selector button on the back of the device for
three seconds. To navigate the menu, use short clicks of the selection button; to change a setting or
advance into a menu item press and hold the button. The menu tree is shown in the table below.
Gateway Menu Tree
 SET IP ADDRESS
 DHCP [ON]
 DHCP [OFF]
 IP
 NETMASK
 GATEWAY
 DNS
 REBOOT
 EXIT - HOLD BUTTON TO EXIT – WILL INDICATE DEVICE IS REBOOTING
 UPDATE
 IP
 NETMASK
 GATEWAY
 TFTP
 DOWNLOAD
 RESTORE FACTORY SETTINGS
 TEST PIN
 RESET
FIRMWARE
DEVICE ID
IP ADDRESS