User Manual

Packet Power™ Smart Power Cable User’s Manual
Copyright 2012 © Packet Power, LLC.
7
Chapter 2: Installation
Installing the Cables
1
Confirm that the cable is correctly rated for the power and
voltage.
2
Make sure that any devices that may be interrupted by the
process are safely powered down.
3
While Smart Power Cables can be plugged into an energized
source, It is recommended for that if possible, the power
source energizing the Smart Power Cable be turn-off during
installation.
4
Remove any existing power cables
5
Plug-in the supply-side (plug or “male”) connector of the Smart
Power Cable into to the power source. (1)
Connect the load side (receptacle or “female”) connector of
the Smart Power Cable to the load device or power strip. (2)
6
If the source power was disconnected, reconnect the source
power.