User Manual

Packet Power™ Wireless Current Monitoring Module Manual

5. Power Supply Connector Kit (not shown)

Mounting the CMM

The CMM mounts in any standard electrical enclosure by placing a 1” NPT hole in the

enclosure. The threaded tube of the module is placed in the hole, and the bezel nut is used

to secure the CMM against the enclosure surface.

Figure 3: Mounting Dimensions

Note: If the current transformer(s) are located in the same enclosure as the CMM,

you must ensure that any electrical code fill rate requirements are being met.

Figure 2: CMM system components

Comment [SV1]: The diameter of a 1" NPT hole

is 1.25"