User Manual

Packet Power™ Wireless Current Monitoring Module Manual
Copyright 2009-2013 Packet Power, LLC.
8
LED readings and indicator lights
The CMM has 4 large alpha-numeric LEDs that provide for local display of monitoring
data and x small lights adjacent to the LEDs that provide operating status information.
The CMM can be configured to display all or some of the following data via the numeric
LEDs. The order of display can also be customized. The data type indicator is shown
followed by the corresponding value, e.g. to show a reading of 10.1 amps on channel A,
the PMM displays “A1” followed by “10.1”.
 P5= XXX firmware version
 Id = ABC last 3 digits of the Packet Power node ID
 C1….C6 = current on channel 1-6 in Amps
 A1…A6 = Current utilization hours on channel 1-6 in Amps Hours
 T = Internal temperature in °C/°F
The 3 status lights are interpreted as follows (top, middle and bottom positions assume
that the PMM is viewed such that the status lights are to the right of the large LEDs):
Top small light (green)
 900MHz radio activity
o off: disabled
o solid on: active, not connected
o slow flashing: active, connected to the mesh network
o very rapid flashing: test/configuration mode
Figure 6: CT polarity and orientation