User Manual

Packet Power™ Wireless Smart DC Monitoring System Manual
Copyright 2015 © Packet Power, LLC.
1
Safety summary and specifications
This manual is intended for use by personnel responsible for installing the Packet Power
Wireless Smart DC Monitoring System. Packet Power LLC assumes no liability for user’s
failure to comply with these safety guidelines. Please read this manual carefully before
proceeding.
This symbol is used throughout this manual to indicate critical safety
information. Failure to observe the information following this symbol may
result in injury or death.
 Wireless Smart DC Monitors should only be connected to the type of power source indicated on the
label or manual.
 Do not connect to AC line voltage sources. For use with DC power sources only.
 Wiring must have the appropriate electrical rating.
 Adhere to all local and national electrical codes and guidelines.
 Prior to installation, check to make sure the Smart DC Monitor has not been damaged.
 Store in a clean, dry location.
 Intended for indoor use only. Do not install in a wet location.
 No field-serviceable parts. Do not attempt to disassemble the product as potentially severe electrical
shock may result. Installation and maintenance must be performed by qualified personnel.
 This product is intended for installation in an approved fire enclosure.
 Failure to use the product in the specified manner may lead to injury or death and damage to
equipment.
 The voltage monitor is certified for use in Measurement Category IV metering applications per part 5.4.1
of IEC 61010-2-030.