User Manual

Packet Power™ Wireless Smart DC Monitoring System Manual
Copyright 2015 © Packet Power, LLC.
15
Technical Specifications
Communications
Operating frequenc
y
2.4 GHz
Wireless protocol
Proprietary frequency hopping, self-configuring, load-balancing mesh network
Wired network protocol
TCP/IP (one IP address needed per Gateway), support for Modbus TCP/IP and
SNMP protocols
Firmware updates
Wireless
Typical transmission
range
10 to 50 meters indoors from any one device to any other
Antenna
Fully enclosed, fixed configuration
Monito
r
to Gateway ratio
Up to 150 cables per gateway (unlimited Gateways per system)
Multi-site support
Yes
Encryption
Optional 128-bit
Environmental and Power Usage
Operating temperature
-7° to +70°C (+20° to +113°F)
Operating humidit
y
5% to 95% non-condensing
Water and dust resistance
Indoor applications
Max. operating altitude
3,300 meters (10,000 feet)
Power usage
< 0.25W
Outputs (Optional Display Module)
LED status indicators
Power (Red / Orange), Status (Red/Orange), Communications (Green)
Local displa
y
3 Digit LED (cycles Amps, Volts, Watts by phase);
Monitored points
Voltage (V), Current (A), Power (W), (Ah)
Measured Parameters
System Level
Voltage (V), Current (A), Power (W), Energy Usage (Ah)
Measurement Categor
y
Measurement Category IV (applicable to voltage monitor only)
Size and Weight
V
oltage Monito
r
52mm x 35mm x 25mm
Current Monitor
(Integrated CT)
65mm x 35mm x 25mm
Current Monitor (Remote
CT)
52mm x 35mm x25mm
5 VDC Power Suppl
y
90mm x 40mm x 30mm
Display Module /
Wireless Hub
Display Bezel: 51 mm diameter x 20 mm H: Stem: 32 mm diameter x 13mm H
Remote CTs
Consult CT specification sheet