User's Manual

3. Load the tray full of slides, and then begin your scanning
4. Go to Scan – Scan – Multi-Scan to file – set Range 1-50 more detailed information below
NOTE: If the scanner sits quietly for 10-15 minutes it will go to sleep and loose communication
EXAMPLE: You set it up to scan a tray, then walk away, it then finishes and has been sitting, the software will then
produce “Unable to communicate” errors
TO FIX: You must Close Cyberview, Turn off the scanner, wait 10 seconds, turn on the scanner and then wait for the full
warm up to a solid green light before starting the Cyberview software again.
Advanced Tips
Slide numbering tips
Go to Scan – Preference - Positive Film – This is where you will set up your desired configuration settings
Directory – This is where the files will be saved to
31
To change the Default Save to location select BROWSE