User Manual

1﹒Mounted Slides…

1. Open Scanner Lid (1).

2. Release the Slide Holder (5) put in slide then close slide holder.

3. Close Scanner Lid (1).

4. Ready to scan.

2﹒Filmstrips…

1. Open the scanner lid (1).

2. Release the Slide Holder (5).

3. Position the film that you wish to scan in the center of the

viewing window (6).

4. Push down the film frame and close the slide holder.

5. Ready to scan.

3﹒One Button Scan…

There is one “SCAN” button on the front panel of scanner. It could be used to

directly save the scanning image files into the designated folder.

Open the CyberView X – SF User Interface FIRST and press the “SCAN“ button

for one button scan function. There are 2 way to open the CyberView X–SF:

1. Open the imaging application and acquire the CyberView X-SF, you can also

refer to Page 6 to acquire the CyberView X-SF User Interface.

1-1. Select the film type and resolution.

1-2. Press the scan button then scanner will auto scan a current film and

digitize to the application software which you open.

2. Select “Start > Programs > CyberView X_SF“ and select “CyberView X“ to

open the CyberView X application loader.

2-1. Select the film type and resolution you want to scan.

2-2. Press the scan button and it’ll pop-up the “Save To Files“ setting, input the

save path, file name and file type, you can also refer to Page 10 to change

the setting.

2-3. After setting, click “OK“ to scan the image to file.

NOTE: If you do not open CyberViewX – SF FIRST, the scan button function

would useless.