Instructions / Assembly

End Stop
(part #5)
rev. 6-10-17 page 5 of 5
J-HOOK/HANGER INSTALLATION (continued)
Figure 11Figure 10
Figure 9
Anti-Jump Disc
(part #6)
3/8” from
edge of door
approximately 2” in
from end of track
End Stop
(part #4)
3. On both ends of track, install end stops (part #5) approximately 2” in from the end of the track to
prevent door from rolling off (figure 9).
4. Prior to installing the anti-jump discs (part #6), operate the door back and forth carefully to check
all clearances.
5. Once clearances and proper door operation are established, install anti-jump discs as shown 6” to
8” from edge of door (figure 10).
6. Install T-guide (part #3) on floor. With door hanging vertical (check with level), measure from wall
to the middle of the groove in the bottom edge of door. Slide door carefully (so as to not have the
door come off the track) all the way to the other end of the track. Install T-guide. Roll door back to
middle. (figure 11)
7. Adjust end stops to desired location. Note: based on door width used, end stop may be required to
slide on track prior to securing last stand off.
T-Guide
(part #3)