Instructions / Assembly

rev. 6-10-17 page 3 of 5 - continued -
TRACK INSTALLATION
3. Using hex head lag bolts (part #7) install track (part #10) with standoffs (part #1) between head casing and
track (figure 5). Postion the track connector screw holes toward the center. Repeat for second track. *Note: Lag
bolts should not be totally tight for initial install.
4. Install track connector bracket (part #9) using allen wrench (part #11) to tighten track connector bracket screws
(part #8). (Figure 6)
5. Tighten all lag bolts after making sure track is level and doors operate properly.
Track
(part #8)
Hex Head Lag Bolt
(part #7)
Standos
(part #1)
Figure 5
3/16” pilot hole
head
casing
overall height from oor
to centerline of holes
is door height + 1-3/4”
(ie, 84” door + 1-3/4” = 85-3/4”)
head casing
Figure 3
MAKE SURE hole marks
are level before drilling
Figure 4
8”16”16” 16” 16” 16”
drill 3/16” pilot holes
where marked
head casing
8” 16” 16” 16” 16”
MAKE SURE hole marks
are level before drilling
drill 3/16” pilot holes
where marked
Figure 6
Track Connector Screw Holes
1. Install track by first measuring/marking hole location on the head casing (figure 3 & 4).
2. Drill 3/16” pilot holes (figure 4). MAKE SURE hole marks are level before drilling.
Track Connector
(part #9)
Track Connector Screws
(part #8)
Allen wrench
(part #11)
Track 2
(part #10)
Track Connector
(part #9)
Track 1
(part #10)