Installation Instructions

The manual of the item SW79777WM
1:Function:Steady- Flash -Off ,when operation the front light ,the function of
the rear light is the same .If the rear light didn’t received the signal from front
light ,the front light will quick flash to remind this situation .if the client just wish
to use the front light ,press the button more than 3 seconds. if client wish to
use the two light’s together ,press the light one time ,then the rear light with
battery will start to work .
2:Code processing: long press the front light button for 10 seconds to enter the
code mode, at this time, the rear light battery can be installed to the code
3:Both front and rear light have low battery indicator .
4:Front light : Lithium polymerbattery 3.7V ,1200MA .rear light:3V ,AAA*2
5:When charge the front light ,the green led will be on ,when finish charge ,the
green led will be off .the charging time is around 3 hours .
6:Long press the button for 60 seconds to enter the test mode, short press to
switch the frequency point/carrier, and long press 5 seconds to exit the test
mode.The eighth pin of receiver chip is connected to a ground button, long
press 5 seconds to enter the test mode, long press 3 seconds to enter the
code mode, short press to switch the frequency point carrier.
Attention:
1:The rear light is under low power consumption standby mode ,if long time
no use the light ,pls take the battery out to aviod the weeping happen
2:Under the situation of turn off ,when restart the rear light , it will need around
2 seconds ,this is normal situation .
3:Please take attention that changes or modification not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
This equipment complies with FCC/IC RSS-102 radiation exposure limits set
forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.