Installation Instructions

• DO NOT mix old and new baeries.
• DO NOT mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) baeries.
• Non-rechargeable baeries are not to be recharged. Baeries are to be inserted with the correct polarity. Exhausted baeries are
to be removed from the toy. The supply terminals are not to be short-circuited. Rechargeable baeries are only to be charged
under adult supervision.
• Rechargeable baeries are to be removed from the toy before being charged.
❶ The speed indicators will ash 3 mes when the baeries
are installed.
❷ Press the Car Select indicator for approximately 2 seconds.
The Car Select indicator will ash.
❸ Press the On/O switch on the car immediately. If the Car
Select indicator is not illuminated, repeat step 2.
❶ Remove the small screw from the baery compartment
cover.
❷ Li the baery cover o the remote control.
❸ Insert two AAA-size baeries into the baery compartment
as shown.
❹ Replace the baery compartment cover and fasten with the
small screw you removed in step one.
❸
13
WARNING
Insert the baeries (Remote baeries not included) Pairing the remote control to the ride-on
This device complies with part 15 of the FCC rules. Operaon is subject to the following two condions: 1. This device may not cause
harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired
operaon.
Press the le buon to
turn le, press the right
buon to turn right.
Car select
Indicator
Speed
indicator
Press the top buon to
move forward, press the
boom buon to move
in reverse.
Reminder: The remote control is for adult use only.
Please refer to page 2 for addional safe riding warnings.
Keep the stop buon pressed down to override or
prevent further ride-on movement. Release stop
buon to transfer control back to rider.
Pairing the Remote Control to the Ride-on
Remote Control Use and Funcons
❶
❷
❸
❷
❶