Installation Guide

2
/
2
B
CC
AA
BB
A
1.. Place the table top (A) upside down on a flat, smooth surface.
Align table legs (B) to the table top. Attach table legs to the table top with washers (BB) and bolts (AA).
Tighten bolts with hand only. Do not fully tighten bolts until the end of Step 2.
BB
AA
CC
C
2.. Align leg connector bracket (C) to table legs.
Attach the leg connector bracket to table legs with washers (BB) and bolts (AA) .
Fully tighten all the bolts using hex wrench (DD) once all of them are in position.
Cover all the bolts with bolt caps (CC).
3.. Turn the table upright. Level the table with foot glides if necessary.
Important:
Please always have an umbrella base ready if you plan to set an umbrella in the center of the table.
Please always close or take down the umbrella after use.
Failure to do so will possibly damage the table.