User's Guide

8
9
clarisonic.com
push
down
to
remove
1
pull
away
2
align
to
mount
3
snap
5
push
down
4
…
a
n
d
t
w
i
s
t
…
a
n
d
t
w
i
s
t
3 pins
and 3
notches
The cleansing duration selections are indicated by three
different audible sequences:
Audible indication Cleansing duration T-TIMER™ beeps
1 long beep & 2 minutes at 40, 80, and 100
2 short beeps seconds
1 long beep only 2 minutes none
1 long beep & 1 minute (this is factory at 20, 40, and 50
1 short beep selected default) seconds
Note: changing the duration time resets the power level.
See Power Level to modify this setting after you’ve
selected the cleansing timer setting.
CHARGING
Your system kit includes a charging cradle designed
to hold and charge the brush handle. Place the Clarisonic
into the charging cradle with the brush facing the raised
wave of the cradle (the brush head is on the same side as
the power cord). The green light on the back of the brush
is the charge indicator. When flashing green the Clarisonic
is charging; a constant green light indicates that your
Clarisonic is fully charged. The Clarisonic includes nickel
metal hydride (NiMH) batteries and cannot be over-charged.
You can leave the Clarisonic brush handle in the charging
cradle or by the sink, tub or shower, as long as you charge
it after every 30 minutes of use. We recommend that you
leave your Clarisonic in its charging cradle when not in use.
When the battery is low, the Clarisonic will beep
5 times while the yellow and green lights flash 5 times.
Place your Clarisonic in its charging cradle overnight to
recharge it. A full charge allows 30 minutes of use.
If it is used for more than 30 minutes without being
charged, the brush handle will beep immediately after use
to alert you to place it in the cradle for charging.
CARING FOR YOUR CLARISONIC
To keep your Clarisonic in optimum condition, care for it
as follows. Do not use abrasive cleaners or chemicals to
clean any part of the Clarisonic. Do not put any part of the
Clarisonic in a dishwasher.
BRUSH HANDLE
Once a week wash the handle using warm soapy water to
remove any residue buildup. The handle is sealed and fully
waterproof. Never attempt to open the brush handle for any
reason.
CHARGING CRADLE
IMPORTANT: Unplug the charging cradle before you clean
it. After unplugging the cradle, wipe it with a soft, damp
cloth. Do not immerse the charging cradle in water.
BRUSH HEADS
We recommend that the Clarisonic brush heads be replaced
every 90 days as the bristles become fatigued and less
effective over time. Once a week, remove the brush head
from the handle and rinse with warm soapy water to
remove any residue.
To remove
the brush head,
1
simply grip the brush head
firmly, then push and twist it counter-clockwise. Then
2
pull the head away from the handle.
To mount
the brush head,
3
align the 3 notches
with the 3 pins, then
4
push down and twist the head
clockwise until it
5
snaps into place. Be sure you hear
a tight snap to ensure the brush head is in place.
Purchase replacement brush heads from your skin care
professional, physician, medi-spa or Clarisonic retailer. Or
call 1-888-525 - 2747 or visit clarisonic.com.