INSTALLATION GUIDE Arlington Single Lever Bathroom Faucet W/ Pop Up PB-L03
RECOMMENDED TOOLS AND MATERIALS ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ Plumbers Putty Silicone Sealant Adjustable Wrench Tape Measure Basin Wrench Phillips Screwdriver Pencil Masking Tape BEFORE YOU BEGIN There are a variety of things to do before installing any new plumbing system into your home or residence.
INSTALLATION OF THE FAUCET Before starting turn off both the hot and cold water supply lines and remove the old faucet. Clean around all areas of attachment before placing new faucet on sink to help prevent corrosion after installation. Parts List Faucet Lock-nut Base Plate Horizontal Pivot Rod Plastic Lock-Nut 1 Plastic Washer Rubber Seal Clevis Retaining Nut Stopper Rod Stopper Secure Faucet Remove the lock-nut provided. Plumbers Putty can be used to secure the base plate.
2 Install Drain Remove the stopper from the drain and unscrew drain from plastic pipe. Remove plastic locknut, washer, and rubber seal from the drain. Apply plumbers putty or Silicone sealant to the bottom edges of the drain. Once applied, press firmly into place (note: there should be excess plumbers putty pushing out from the edges. This can be removed later). Attach rubber seal, washer, and lock-nut back onto bottom of sink.
3 Install Horizontal Pivot Rod Remove the Retaining nut being sure to leave the plastic ring inside. Remove the Metal spring attached to the horizontal pivot rod, set aside. Insert the horizontal pivot rod, ball first, into the pipe. Feed the retaining nut over the rod and lightly attach without tightening.
5 Attach Clevis Put the spring from the horizontal pivot rod halfway onto the rod. While it is still half on attach the clevis (choosing the hole to match the needed height for your sink or preference). Lock the clevis into place by completely attaching the spring and sliding it along the horizontal pivot rod to a desired location. 6 Attach Stopper Rod Loosen the clevis screw until you can insert the stopper rod.
Connect Supplies With the stopper correctly installed (you should be able to push it up and down now) securely attach supply lines to the faucet base followed by the water source. Tighten all connections with wrench to ensure that no leaking occurs. With all pipe attachments plumbers tape can be utilized to help reduce the risk of leaking. 8 Flush Lines Remove the aerator. Turn on the hot and cold water supply lines. Turn the faucet handle to the cold side and lift the handle to the “on” position.
Limited Lifetime Warranty Pacific Bay products have been manufactured under the highest standards of quality and workmanship. Pacific Bay warrants to the original purchaser for as long as the original purchaser owns their home that this faucet will be leak- and drip-free during normal use and that all parts and finishes of this faucet will be free from defects in material and manufacturing workmanship.
