Software manual User Manual

Chapter 3
SETTING THE
MODEM AND
RS-232
The AeGIS 9000 Series can be program via Modem (remote) or RS-232 (local). If the RS-232 is used to program the
system, you have to build the RS-232 cable, see the AeGIS 9000 Series Installation and Program Manual for pins
configuration.
3.1 MODEM
Internal and external modem can be used with the software. Some modems may be incompatible with our software. Pach
and Company will not responsible for incompatibility problem. Recommended modem brand is ZOOM, SUPRAMAX or
1200 HAYES COMPATIBLE.
Step 1 Find the Comm Port where the modem is installed. Refer to the Computer Operating System owners manual to
locate the modem port.
Step 2 Open the AeGIS Management Software Program as shown on figure 3.1
Figure 3.1
Step 3 Select the Comm Mode to Modem as shown on figure 3.1.
Step 4 Select the Port number (1-4).
Step 5 Set the Modem Comm Setting String and Byte Cycle by clicking your mouse at Setting Menu, the screen shows as
on figure 3.2.
Pach and Company Chapter 3 Page 4
AeGIS 9000 Series Management Software SETTING 03/01/02