User guide

AeGISNPB7000P Page22

2. Press 1= enable or 0= disable then press #
76
OPENNING DOOR BEEP OFF
1= enable (beep on)
0= disable (beep off)
Default is 1 (enable)
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 76 then press #
2. Press 1= enable or 0= disable then press #
77
PBX
Not Applicable
Not Applicable
78
VIEW DIRECTORY BY NAME
Directory number can be viewed if the tenant name is
programmed into the directory.
Tenant’s name will show in alphabetical order.
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 78 then press #, the
display will show as an example shown
2. Press
3- scroll A-Z
6- scroll Z-A
3. Press # to view the directory associated with
the tenant’s name.
4. Repeat step 2 to view next tenant’s directory.
91
TOTAL NUMBER OF TENANT DIRECTORY
Number of tenants are occupied the system memory
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 91 then press #
2. The display above is shown the total number
of tenant’s directory is 25
UnlockBeep(1,0)1
WARNING:IFTHEDIRECTORYIS
USEDTOPROGRAMTHE4‐DIGITACCESS
CODEORTELEPHONENUMBERWITHOUT
NAME,THENFUNCTIONCODE78WILLNOT
WORK
PACHANDCOMPANY
DIR:001
TotalTnT:025