User guide

AeGISNPB7000P Page20

40
MASTER CODE MASK
0= Unmask
1=Mask
Default is Unmasked
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 40 then press #
2. Select 0=Unmask or 1=Mask then press #
46
FIRMWARE VERSION
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 46 then press #
V:7150 is model number 7150P
01/28/11 is firmware release date
50
ERASE MEMORY TO FACTORY DEFAULT
SETTING
1= Erase
0= Cancel
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 50 then press #
2. Press 1= erase or 0= cancel then press #
51
ENABLE NO PHONE BILL
0= Dedicated phone line
1= no phone bill
Default is 0
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 51 then press #
2. Press 0= dedicated phone line or 1= no phone
bill then press #
MC_MASK1=YES:0
WARNING:MASKINGTHEMASTERCODE
WILLDISABLETHERETRIEVALBUTTON.THERE
ISN’TAWAYTORECOVERTHEMASTERCODE.
PACHANDCOMPANYWILLNOTCOVERTHE
WARRANTYIFTHEMASTERCODEHASBEEN
FORGOTTEN.

IFYOUARETHEINSTALLERDONOTMASKTHE
MASTERCODE.
V:715001/28/11
1toConfirm:_
WARNING:SYSTEMWILLBERESTOREDTO
FACTORYDEFAULT,ALLDATABASESWILLBE
ERASED,NOWAYTORECOVER.
NPB[01]:0