User guide

AeGISNPB7000P Page19

2. Replace the directory digit to 2 or 4 digit, then
press #
07
SINGLE OR MULTI SYSTEM
1= Single 0= Multi
Default is single
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 07 then press #
2. Select 1 or 0 then press #
08
SYSTEM ID
Not applicable
Not Applicable
10
WELCOME MESSAGE
Welcomemessageisupto
48‐charactersanddividedinto
3‐segmentsand16‐charactersforeach
segment
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 10 then press #
1
st
segment
2. Change the welcome screen, , see (Keypad
Function and Layout page 14).
3. Press # after entering the last letter on 1
st
segment
2
nd
segment
4. Press # after entering the last letter on 2
nd
segment
3
rd
segment
5. Press # after entering the last letter on 3
rd
segment.
DIRDIGITS:3
NOTE:ALLTENANTDIRECTORIESMUSTHAVE
SAMENUMBEROFDIGIT
Wait…..
WARNING:CHANGINGTHEDIRECTORYDIGIT
WILLERASEALLTENANTDIRECTORY
NOTE:SETTOMULTIIFMORETHANONESYSTEM
SHARINGONEPHONELINE
SING=1,MULT=0:1
WelcometoPach’
sTelephoneAcce
ssSystem…
**