User guide

AeGISNPB7000P Page18

press #,
5. Enter 4-digit access code then press #.
Repeat step 1 to edit another tenant directory.
03
DELETING A DIRECTORY
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 03 then press #
2. Enter directory number to be deleted (i.e.
directory 001) then press #
04
DELETING ALL DIRECTORY
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 04 then press #
2. Press 13 then #
3. Press 5 then #
05
MANUAL OPEN AND CLOSE RELAY 1
00= close
01-99= open 01-98 hours timer
99= open for indefinite time
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 05 then press #
2. Enter 01-98 hours timer, 00=close or 99= open
for indefinite time then press #, hear
beep
beep!!!
06
DIRECTORY DIGIT
2, 3 or 4 digit
Default is 3-digit
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 06 then press #
AccessCode:____
DeleteDir:___
001isdeleted!
Deleteall?13
Areyousure?5
NOTE:IFDIRECTORYDOESNOTEXIST,THE
DISPLAYWILLSHOW
ErroronDelete!
OPEN:00HOURS