User guide

AeGISNPB7000P Page12

Checking your installation
1. Turn the “Power” On, the display will go into cycle mode as show
2. Check for the tone on the keypad buttons 0-9, # and *
3. Clear the memory.
4. Adjust the speaker volume, press # wait for dial tone, clockwise-decrease, counter clockwise-increase
refer to figure 2.1
5. Adjust the display intensity refer to figure 2.1
LCDDISPLAYOK FLASHOK DTMFOK
INITSTART COMPLETE... WelcometoPach’s


WARNING:IFTHEDISPLAYSHOWSBLANKSCREEN,TURNTHESYSTEMIMMEDIATELY
REFERTOFUNCTIONCODE50TOCLEARSYSTEM’SMEMORY