Owner manual

AeGIS8000P Page20

46
FIRMWARE VERSION
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 46 then press #
V:8250 is model number 8250P
02/16/11 is firmware release date
50
ERASE MEMORY TO FACTORY DEFAULT
SETTING
1= Erase
0= Cancel
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 50 then press #
2. Press 1= erase or 0= cancel then press #
51
ENABLE NO PHONE BILL
Not applicable
Not applicable
70
MODEM PROTOCOL
0= Bell
1= V22
Default is V22
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 70 then press #
2. Press 1= V22 or 0= BELL then press #
71
ENABLE MODEM
0= Disable
1= Enable
Default is Enable
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 71 then press #
WARNING:MASKINGTHEMASTERCODE
WILLDISABLETHERETRIEVALBUTTON.THERE
ISN’TAWAYTORECOVERTHEMASTERCODE.
PACHANDCOMPANYWILLNOTCOVERTHE
WARRANTYIFTHEMASTERCODEHASBEEN
FORGOTTEN.

IFYOUARETHEINSTALLERDONOTMASKTHE
MASTERCODE.
V:825002/16/11
1toConfirm:_
WARNING:SYSTEMWILLBERESTOREDTO
FACTORYDEFAULT,ALLDATABASESWILLBE
ERASED,NOWAYTORECOVER.
1_V22,0_BELL:1