Manual

Pach and Company Chapter 3 Page 11
AeGIS 8000 Series PROGRAMMING
FUNCTION CODE PROGRAMMING
05
MANUAL UNLOCK AND LOCK RELAY 1
(DOOR 1)
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 05 then press #, the display will show
Step 3 Enter • 01-98 hours to unlock door 1
• 99 hours to unlock door 1 for indefinite time
• 00 hours to lock door 1
then press # or
*
to cancel.
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
06
MANUAL UNLOCK AND LOCK RELAY 2
(DOOR 2)
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 06 then press #, the display will show
Step 3 Enter • 01-98 hours to unlock door 1
• 99 hours to unlock door 1 for indefinite time
• 00 hours to lock door 1
then press # or
*
to cancel.
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
07
SINGLE OR MULTI SYSTEMS
(DEFAULT SETTING IS=1 FOR
SINGLE)
SINGLE: one system connects to a phone line.
MULTI: more the one systems connect to a
phone line (sharing the phone line).
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 07 then press #, the display will show
Step 3 Enter • 1 for Single system
• 0 for multi systems
then press # or
*
to keep the current setting.
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
Select Func: _ _
OPEN1:00 HOURS
Select Func: _ _
OPEN2:00 HOURS
Select Func: _ _
SING=1, MULT=0: 1