Manual

FUNCTION CODE PROGRAMMING

Step 6 • To change the access code, press * then enter a new one then

press #.

• To keep the current access code, press #

Step 7 Proceed to step 2 and select the same function code or different

function code to continue programming or press

to exit the

programming mode and you will hear “ three short beeps”.

DELETE AN EXISTING TENANT

You must know the directory code to delete an

existing tenant. Delete any unused directory to

free the memory.

Step 1 Log on to programming mode, see instruction above. The display

will show

Step 2 Enter function code 03 then press #, the display will show

Step 3 Enter the tenant directory code to be deleted then press #, the

display will show

If the directory code does not exist, the display will show

Step 4 Proceed to step 2 and select the same function code or different

function code to continue programming or press

to exit the

programming mode and you will hear “ three short beeps”.

CLEAR ALL TENANT DIRECTORY CODES

Step 1 Log on to programming mode, see instruction above. The display

will show

Step 2 Enter function code 04 then press #, the display will show

Step 3 • Press 13 then #, the display will show

then proceed to step 4 or

• Press

to cancel deletion and you will hear “one long beep” and

proceed to step 5.

Step 4 Press 5 the # to delete or press

to cancel deletion.

Step 5 Proceed to step 2 and select the same function code or different

function code to continue programming or press

to exit the

programming mode and you will hear “ three short beeps”.

Access Code: current code

Pach and Company Chapter 3 Page 10

AeGIS 8000 Series PROGRAMMING

Select Func: _ _

Delete Dir: _ _ _

(Dir Code) is deleted !

Error on Delete !

Select Func: _ _

Delete all ? 13

Are you sure ? 5