Manual

AeGIS7000P Page20
2. Press 1= enable or 0= disable then press #
77
PBX
0= disable
1= enable
Default is disable
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 77 then press #
2. Press 1= enable or 0= disable then press #, if
1 is selected, the screen will show:
3. Select the number for the PBX to access an
outside line, typically is 9,
4. Select delay time ( 1 second to 5 second),
most PBX will take 1-2 seconds delay time
78
VIEW DIRECTORY BY NAME
Directory number can be viewed if the tenant name is
programmed into the directory.
Tenant’s name will show in alphabetical order.
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 78 then press #, the
display will show as an example shown
2. Press
3- scroll A-Z
6- scroll Z-A
3. Press # to view the directory associated with
the tenant’s name.
4. Repeat step 2 to view next tenant’s directory.
91
TOTAL NUMBER OF TENANT DIRECTORY
Number of tenants are occupied the system memory
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 91 then press #
2. The display above is shown the total number
of tenant’s directory is 2
UnlockBeep(1,0)1
WARNING:IFTHEDIRECTORYIS
USEDTOPROGRAMTHE4‐DIGITACCESS
CODEORTELEPHONENUMBERWITHOUT
NAME,THENFUNCTIONCODE78WILLNOT
WORK
PACHANDCOMPANY
DIR:001
TotalTnT:025
PBX_EN(1,0):0
PBX_No(0‐9):_
Delay(1‐5S):