Manual

AeGIS7000P Page17
press #
07
SINGLE OR MULTI SYSTEM
1= Single 0= Multi
Default is single
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 07 then press #
2. Select 1 or 0 then press #
08
SYSTEM ID
Not applicable
Not Applicable
10
WELCOME MESSAGE
Welcome message is up to
48-characters and divided into
3- segments and 16-characters for each
segment
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 10 then press #
1
st
segment
2. Change the welcome screen, , see (Keypad
Function and Layout page 14).
3. Press # after entering the last letter on 1
st
segment
2
nd
segment
4. Press # after entering the last letter on 2
nd
segment
3
rd
segment
5. Press # after entering the last letter on 3
rd
segment.
40
MASTER CODE MASK
0= Unmask
1=Mask
Default is Unmasked
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 40 then press #
Wait…..
WARNING:CHANGINGTHEDIRECTORYDIGIT
WILLERASEALLTENANTDIRECTORY
NOTE:SETTOMULTIIFMORETHANONESYSTEM
SHARINGONEPHONELINE
SING=1,MULT=0:1
WelcometoPach’
sTelephoneAcce
ssSystem…
**