Operation Manual

16
OPERATING YOUR SET-TOP (cont.)
Using your remote control
It is your cable TV service provider that determines the digital channels, services and screen
information that you see on your TV when you use your set-top and its remote control.
Consult the information supplied by your cable operator for details on how to make the most of the
digital cable services. Also read the operating instructions that are supplied with your remote control.
Activating baseband loopthrough for a DVD or similar
equipment
If you activate baseband loopthrough, your set-top loops the baseband inputs on its rear panel to the
baseband outputs as shown in the table below. You need to do this if you have connected a DVD
player or similar equipment and wish to watch it on your TV.
COMPONENT VIDEO IN loops through to COMPONENT VIDEO OUT
VIDEO IN loops through to VIDEO OUT
AUDIO IN loops through to PRIMARY AUDIO OUT and
SECONDARY AUDIO OUT
DIGITAL AUDIO IN loops through to DIGITAL AUDIO OUT
OPTICAL AUDIO IN loops through to OPTICAL AUDIO OUT
To activate baseband loopthrough, simply turn off your set-top by pressing the POWER button on
the remote (making sure the remote control is set to control the set-top) or by pressing the power
button on the front panel. When your set-top is turned off, the light next to the power button is
red.
NOTE
Depending on your set-top’s
settings, if you put turn off your
set-top, any TV that is attached to
your set-top’s POWER OUTLET
may also turn off. For more
details, see page 34.