User Manual

Chapter 2 Installing your gateway 11
After your gateway recognizes the wireless device, the WIRELESS indicator turns
steady green, and blinks when the wireless device starts communicating with your
gateway.
You can use WPS (Wi-Fi Protected Setup) to simplify the process of connecting
wireless devices to the network. For more information, go to the gateway configuration
page at http://192.168.1.254
Connecting phones
The gateway includes one RJ-14 port (Phone 1 & 2) with the capacity to support 2
phone lines using a splitter or multi-jack adapter.
WARNING: Do not connect the VoIP lines to your current home telephone wiring,
especially if your home has an alarm system. Ensure that you are subscribed to VoIP
service before configuring VoIP on the gateway.
1. Connect one end of the phone cable to the gray FXS 1 & 2 port on your gateway.
2. Do one of the following:
• For one phone, connect the phone cable directly to the telephone.
• For two phones, connect the phone cable to a splitter and then to the
telephones.
USB
LAN
1
2
3
4
W
A
N
DSL
FXS
1&2
RESET
POWER
1/0