User Manual

Read the instructions carefully before you start. These instructions are written for one-person installation. We
have noted where briefl y having an extra person’s assistance can make installation easier. If you have questions
regarding the installation please call our Technical Support Line at [phone].
CONTRACTOR RIG RACK
9/16” wrench or socket
1/2” open ended wrench
Flat clean surface (such as card board paper or plastic
Silicone sealant (if necessary)
2
TOOLS REQUIRED FOR ASSEMBLY:
BEFORE YOU START:
UTILITY RIG RACK ILLUSTRATION:
EXTENSION BEAMS (x4-HALFS)
BRACES (x 4)
LEGS (x4)
EXPLORER SERIES
RAIL (ORDERED
SEPARATELY
WITH TRUCK BED
COVER)
IMPORTANT! The Pace Edwards truck bed cover and Explorer Series Rails
MUST be installed on the truck fi rst before attempting to install this rack system!
LADDER GLIDE
PLASTIC INSERT IN
REAR T-SLOT (x1)
THIS TAB FITS INSIDE
CROSSMEMBER
REAR FRONT
DETAIL OF CONTRACTOR
RIG GUSSET & BRACE
INSTALLATION
TRUSS
CROSSMEMBER (x2)
EXT. BEAM
CROSSMEMBER (x1)
RUBBER ANTI-
WEAR INSERT (x3)
HEAVY
GUSSETS (x 4)
TRUSS
MOUNTS (x4)