Owner's Manual

Radio Replacement &
Steering Wheel Control Interface
for Select Hyundai Vehicles
RP4.2-HY11
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 6
Rev: 2
Date: 092118
RadioPRO App
Use of the RadioPRO App in Hyundai allows you to do the following:
• Congure User Interface Options such as:
• Red/White wire output behavior
• Factory amplier settings (Bass, Mid, Treble, Gain, Fader and Balance)
• Update Product Firmware
• Read Firmware/Hardware Versions
• Access Product User Manuals
Programmable Red/White Wire
The red/white wire can be programmed to do a pulsed or latched trigger that is controlled by a user assigned steering wheel
control button. Select User Interface Options then set the behavior of the red/white wire using the drop down menu.
Latched - This selection will provide a latched 12v+ output
that can be tied to any of the vehicles SWC. This means that
when you press the assigned SWC, the red/white wire will
turn on and remain on until the assigned SWC is pressed
again or the ignition is turned off.
Pulsed - This selection will provide a user programmable timed
12v+ output that can be tied to any of the vehicles SWC. This
means that when you press the assigned SWC, the red/white
wire will pulse for the pre-programmed user time. The range for
pulse time is 100 milliseconds - 25.5 seconds (.1-25.5).
Factory Amplier Settings
The RadioPRO app will also allow you to adjust the settings of the factory amplier. You can adjust Amp Gain, Fader, Balance,
Bass, Mid and Treble. Restoring factory settings on the module will default all values back to middle.
Firmware Updates
The RadioPRO app will also allow you to update the interface with new rmware as it becomes available. Please visit www.pac-
audio.com or contact our tech support department to see if there is a rmware update for your interface.