Owner's Manual

Radio Replacement &
Steering Wheel Control Interface
for Select Hyundai Vehicles
RP4.2-HY11
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 4
Rev: 2
Date: 092118
Steering Wheel Controls (cont.)
Alpine JVC Kenwood Clarion Other * Pioneer Sony Fusion
1 Volume + Volume + Volume + Volume + Volume + Volume + Volume + Volume +
2 Volume - Volume - Volume - Volume - Volume - Volume - Volume - Volume -
3 Mute Mute
4 Preset + Source Source Source Preset + Preset + Preset + Source
5 Preset - Track + Play Search + Preset - Preset - Preset - Track +
6 Source Track - Track + Search - Source Source Source / End Call Track -
7 Track + Band / Disc + Track - Band Track + Track + Track + Audio
8 Track - Preset / Disc - Disc / FM + Send / End Track - Track - Track - Power
9 Power Select Disc / AM - Send Band Band Band
10 Enter / Play Attenuation Answer End Answer ** Phone Menu Power / End Call
11 Band / Program Phone Receive
l l aC d nE* * TTPk o oH nOt ce j eR enohPev i eceR21
kooH f fO
Voice
dnE31
14
Power Mute
+ t ese rP51
* Advent, Boyo, Dual, Lightning Audio, Jensen, Rockford Fosgate & Visteon ** Jensen & Advent ONLY ***
XAV-AX100 Only
AT T Mute Mute Mute Mute Mute
Voice
Voice Voice End** Answer Call Voice / Answer / End Call
Voice
Voice (Android Auto & Car Play)
Answer / End Call ***
Optional Programming Order
Optional SWC Programming Procedure
1. Turn the key to the ignition position.
2. Press and release programming button on the side of the interface. The Status LED will turn green.
3. Within 7 seconds, press the button that is to be learned on the steering wheel. The LED will turn red when the button is pressed.
At this point you have two options:
A. For short press functionality: Release the button within 1.5 seconds. The LED will turn back on.
B. For long press functionality: Hold the button until the LED starts blinking. Release the button and the LED will
go back to solid.
4. If you need to program more buttons, repeat step 3 for each additional audio function on the steering wheel.
5. If you come across a function in the chart that your steering wheel does not have, or you do not want to program, press and
release the program button on the side of the interface to skip that function.
6. Once programming is completed, wait seven seconds. The LED will ash three times indicating end of programming.
7. Test the interface for proper functionality. Whenever a SWC is pressed the LED on the interface should blink. If any function
does not work, repeat the programming steps.
Steering Wheel Control Re-Calibration
SWC re-calibration is necessary when the SWC operation in vehicles with analog SWC is erratic or non-existant. This process
re-calibrates the SWC values to the RP4 interface so it will know what they can be set to for button function assignment. The
interface must be programmed in the specic order shown in the chart on the next page. If you come across a function in the
chart that your steering wheel does not have you must press and release the program button on the side of the interface to skip
that function. The LED will ash off and on conrming that you have successfully skipped that function and are ready to proceed
to the next one.
The SWC and radio command assignments can always be restored to default values by entering re-calibration mode (Steps
1-2) and not pressing any buttons. After 7 seconds the re-calibration mode will time out and all default values will be restored.